Data Sheet: Tolerances for Arches
 
 
 
 
 
Arches ≤ 4 Lamellas
Narrow arches with a low number of lamellas have reduced stiffness. It is only possible to observe the tolerances referred to above with certainty above 5 lamellas. If in spite of this these tolerances are still too high for your application, it will be necessary to
     rework the arches on the CNC machining centre at additional cost. Generally speaking, an extra lamella is necessary for this.
It is possible that glued joints may be milled in the process depending on the arch length. Note: The MUF glue darkens.		    
Your Enquiries and Orders:
When making enquiries, please provide the following information: Are the arches self-supporting or fixed at several points on supports Which surfaces are visible Should the upper side or underside or both sides of the arch be manufactured accurately

Are the arches self-supporting or fixed at several points on supports
Which surfaces are visible
Should the upper side or underside or both sides of the arch be manufactured accurately